Compatible with general automotive anti-theft alarm systems, featuring one-button engine start/stop locking function.

Features: 1. Audible and visual alarm with emergency alarm function. 2. Strong induction locking function; the vehicle cannot start without a sensor. 3. Exquisite and durable ignition wire, ensuring stable vehicle power. 4. Removable induction coil; easy to install and maintain; recommended installation under the steering wheel. 5. Mold-molded coil, robust and durable; passive ID sensor card; battery-free, perfectly matched, providing a safe and reliable anti-theft function. Specifications: Audible and visual alarm with emergency alarm function. Strong induction locking function; the vehicle cannot start without a sensor. Exquisite and durable ignition wire, ensuring stable vehicle power. Removable induction coil; easy to install and maintain; recommended installation under the steering wheel. Mold-molded coil, robust and durable; passive ID sensor card; battery-free, perfectly matched, providing a safe and reliable anti-theft function. Specifications: Status: Standby current: 8mA (Note: Standby time up to 2 months) Continuous) Button display: Blue light (Off when ignition is off; On when ignition is on; Flashing when car audio is on) Packaging box dimensions: 17 x 14.5 x 5 cm / 6.7 x 5.7 x 2 inches Package contents: 1 x Induction coil 1 x Wiring harness 1 x Main unit 1 x Start button 2 x ID card Installation precautions: 2. If the original car has an anti-theft chip, please remove the original anti-theft chip and paste it to the original car's scannable area; otherwise, it may cause starting failure. 3. Since the base of the start button is made of metal, if it interferes with the original car's anti-theft chip when pasting, please choose another location to paste it or use a shim. 4. This product's output consists of 5 wires: the 12V red wire connects to the original vehicle's ignition wire; the orange ACC wire connects to the original vehicle (usually in position 1); the white ON1 power wire connects to the original vehicle (usually in position 2); the yellow starter wire connects to the original vehicle (this wire is energized momentarily during startup and de-energized after startup); the brown wire connects to the original vehicle's ON2 power wire (this wire is energized when the key is in the ON position, de-energized momentarily during startup, and energized after startup; careful judgment is required during installation). 5. Some vehicle models only have 4 output wires: orange (ACC), white (ON), yellow (ignition starter wire), and red (original vehicle key's ignition wire). The brown wire is either unused or used with the white ON1 wire. 6. When encountering vehicles with 6 output wires, in addition to following the method in section 4 above, you also need to determine the function of the sixth wire. This is done by turning the key to the ACC, ON, and start positions respectively, and checking the power supply to the sixth wire in each of these three different states. When starting, the sixth wire needs power. In this case, the yellow starter wire needs to be connected to the positive and negative terminals or isolated using a relay. When powering on from the ON position, the white wire needs to be connected or power should be isolated using a relay. Please remember this, otherwise starting may be difficult. 7. Unlike the main starter unit (with key start function but no key entry function), it is important to note that the ground wire must be securely connected and should not be too long, otherwise it may damage the vehicle. If it is difficult to start after pressing the brake or the starter indicator light goes out, it may be due to a loose ground wire or poor wiring. 8. Please note that new and old models of this product are shipped randomly. Please ensure you do not mind before placing an order. Packing List