Product Introduction: MKS CANable V2.0 module is an upgraded version of MKS CANable V1.0. CANable 2.0 is a small, low-cost, open-source USB to CAN analyzer. CANable enumerates as a virtual serial port on your computer and acts as a serial line for the CAN bus interface. CANable 2.0 supports standard CAN 2.0A, CAN 2.0B, and CAN FD. Under the premise of high-speed transmission rate and high operational stability, the MKS CANable V2.0 Pro module has stronger anti-interference ability and is suitable for industrial debugging or motor field applications. When using the candleLight firmware, CAN is enumerated as a native CAN interface on Linux. The CANable analyzer is compatible with ARM-based embedded platforms, such as Raspberry Pi, Raspberry Pi Zero, ODROID, Beagle Bone, etc., making it suitable for integration into products. Product Features: 1. Supports CAN 2.0A, CAN 2.0B, baud rate up to 1M; 2. Supports candleLight, slcan firmware; slcan initially supports CAN-FD, test rate up to 2M/5M baud rate; 3. Terminal resistor can be selectively enabled/disabled through the short-circuit cap; 4. Supports Type-C USB interface, online firmware upgrade, and DFU mode firmware upgrade; 5. Uses high-performance ARM Cortex-M4 STM32G431C8T6 processor, operating frequency up to 170MHz; 6. Schematic diagram, firmware, source code, and host computer software provided. Information is complete and easy to use. Analyzer Board Version: V2.0 / V2.0 Pro Material: ABS Color: As shown Package Contents: 1 x USB data cable 1 x 3-pin double Dupont cable 1 x Analyzer board Only the above package content is included; other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture to differ slightly from the real thing. Measurement allowed error is +/- 1-3 cm.