Tattoo Transfer Stencil Machine Copier Printer CIS Scanning Clear Pattern Mode Thermal Tattoo Kit for A5 to A4 Size Documents 100‑240V Item Type: Tattoo Transfer Stencil Machine Material: ABS, Alloy, Electronic Components Scan Mode: CIS Effective Scan Width: 210mm Scan Resolution: Horizontal: 8dot/mm, Vertical: 7.7line/mm Document Type: FINE/PHOTO Document Size: A5-A4 Document Thickness: 0.06mm-0.15mm Printing Mode: TPH Effective Print Width: 210mm Power Consumption: Standby 5W Operating Temperature: 5-35℃ Relative Humidity: 20%-80% Product Size: Approx. 292 x 225 x 84mm / 11.5 x 8.9 x 3.3in Note: 1. For optimal transfer effect, the machine should be rested for a few minutes after transferring 1-2 papers. 2. To protect the machine, it is advised not to make continuous transfers. Allow the machine to cool down after usage. 3. The tattoo stencil machine is not suitable for complex shaded patterns. It can only display a single effect. It is recommended to transfer lines and simple patterns for the best results. How e: 1. Panel Instructions: DEEPNESS I: The indicator light is on, the original document density is set to Deepness I, and the DEEPNESS II button indicator light goes off. DEEPNESS II: The indicator light illuminates, the original document density is set to Deepness II, and the DEEPNESS I button's indicator light goes off. PHOTO: Press this button to switch between picture and fine details; if set to picture, the indicator light will turn on. MIRROR: Press this button to switch between mirror copying and normal copying, the default setting is mirror copying, the indicator light illuminates when set to mirror copying. STOP: Stops the transfer. COPY: Insert the manuscript, then press this button to start transferring. POWER: Power indicator light, it illuminates when the machine is powered on. ERROR: Error indicator light, it lights up when the thermosensitive head overheats. 2. Adjusting the Scanner and Transfer Depth: You can adjust the scanner and print depth of the machine according to your actual needs. The steps are as follows: ① Hold the STOP button for 3 seconds, the machine beeps once, and all indicator lights illuminate. ② Short press the STOP button to adjust the scanning depth, one beep indicates maximum scan depth, seven beeps indicate minimum scan depth. ③ Short press the COPY button to adjust the transfer depth, one beep for the lightest transfer, seven beeps for the deepest transfer. ④ Hold the STOP button for 3 seconds, the machine beeps once, the indicator lights restore, representing completion of scanning and transfer depth adjustment. 3. How to Calibrate the Machine: The image sensor and heat sensor inside the machine are very sensitive to the brightness and temperature of the surrounding environment and naturally change over time. If the color difference between the copied image and the original image is significant, please calibrate the scan in time. To do this, hold the STOP button for 3 seconds without letting go until you hear a beep, then press the MIRROR button once, then the COPY button once. 4. How e: (1) Connect the power supply and turn on the power switch. (2) Open the machine's paper warehouse flap and insert the transfer paper into the transfer paper input port of the machine. (3) Place your draft pattern face down into the manuscript input port. (4) Set up the transfer mode, and press the start button to start transferring once ready.