This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs. It is designed specifically for flight controller that do not have built-in servo header pins like the for 6C & 4. It comes with pre-soldered wires, capacitor, and XT60 connector.It has two power output port with BEC and circuitry. Input voltage: 2S-14S PCB Cont. Current Rating: 90A PCB Burst Current Rating: 140A (Less than 60 Sec) Output: DC 5.2V & 3A Max Please Note: The XT60 Plug and 12AWG wire that are pre-soldered on the board is rating for 30A continuous current and 60A burst current (Less than 60 Seconds). If a higher current is being used, the plug type and wire size should be changed accordingly. This PM02 Power Module uses analog data output and is not compatible to the for 5X & 6X (Requires a digital PM like PM02D). Color: As Shown Material: PC Package Contents: 1 x PM07 Power Management PM Module Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.