Features 1、Scope of Application: This tester can achieve automatic detection of NPN and PNP bipolar transistors, N channel and P channel MOSFETs, JFETs, diodes (including double diodes), N and P IGBTs, resistors (including potentiometers), inductors, capacitors, thyristors, three terminal Triac and battery (0.1‑4.5V). 2、Easy Use: This tester has a stable performance, it can automatically read accurate data, which is easy to use. 3、Graphical Display: 12864LCD graphic display is adopted, the display of the tester is intuitive and the information content is large. 4、Rechargeable: There is a built in lithium ion battery, you can use it for a long time on a single charge. 5、Easy Carrying: Comes with small size and lightweight, you can easily take this tester with you to help with your work. Specification Item Type: Multifunctional Tester Material: ABS Battery: Lithium Battery 800mAh (Built in Battery) Basic Parameters: Display: 160 x 128 TFT Display Note: 1. One key to start and test, automatically identify the device type, automatically switch the range, and automatically shut down after the test. 2. The standby current is as small as 20na, and the standby power is negligible for long standby time, and the battery can be used for power supply. 3. Automatically detect PNP and NPN type bipolar transistors, N, P channel MOSFET, JFET, diode, double diode, thyristor thyristor (thyristor), triode, resistor, capacitor, capacitor ESR value. 4. Automatically detect the pin layout and give the label according to the actual sequence. 10. Supports simultaneous measurement and symbol display of two resistances. Both ends of the displayed resistance symbol are the connected tester probe numbers (1 to 3), and the adjustable potentiometer can also measure 11. The resolution of resistance measurement is 0.1 ohm, and the highest measurement value is 50M ohm. 12. The highest four digits of the capacitance are displayed, and the capacitance value ranges from 25pf (8MHz clock, 50pF at 1MHz clock) to 100mF. Resolution up to 1pF (at 8MHz clock). 13. The equivalent series resistance (ESR) capacitance value of capacitors above 2UF can be measured with a resolution of 0.01 ohms and a two digit value displayed. 15. The LED is detected as a diode, it will flash several times continuously during the test, and the double light emitting diode is detected as a double diode. 17. The capacitance value of the reverse of a single diode can be measured. Bipolar transistors can also be measured. At this time, the base and collector or emitter must be connected. 18. Only one measurement is needed to find out the connection of the full bridge. 19. The maximum capacitance test is 1000000uf, and the best test range is 0.2nF to 7000uF. 20. The inductance test range is: 0.01mH to 20H, more than 20H, resistance below 2100 ohms will be recognized as inductance, the measurement result only shows a single inductance, and the inductance value is displayed. 21. The test time is about two seconds, and the measurement time of bulk capacitance and inductance will be extended with the actual value. 22. Automatically shut down, after the test, the test result will always be displayed for about 25 seconds, and then shut down. 23. Be sure to discharge the capacitor before testing the capacitor, otherwise the tester will be burned. 24. Types of power devices and amplifiers, transformers, etc. are not allowed to be tested or cannot be tested. Package List 1 x Multifunctional Tester 2 x Test Module 1 x Test Cable 3 x Accessory 1 x Instruction Manual 1 x Plastic Box 1 x Data Cable