1、IP67 waterproof power supply, suitable for both outdoor and indoor use, not afraid of rainy, foggy strong sunlight and other harsh environments. 2、The 24V 60W LED driver transformer is widely used for LED spotlights, LED strips, LED street lights, LED bulbs, LED buried lights, LED ceiling lights and other LED lamps. 3、Constant voltage output to ensure the stability of the power supply. 4、The power supply is sealed with high quality aluminum housing, rustproof and anti-corrosion, quick heat dissipation. 5、Overvoltage, Overcurrent, Overheat and Short Circuit protection for safety use. Features: IP67 waterproof power supply, suitable for both outdoor and indoor use, not afraid of rainy, foggy strong sunlight and other harsh environments. The 24V 60W LED driver transformer is widely used for LED spotlights, LED strips, LED street lights, LED bulbs, LED buried lights, LED ceiling lights and other LED lamps. The power supply is sealed with high quality aluminum housing, rustproof and anti-corrosion, quick heat dissipation. Overvoltage, Overcurrent, Overheat and Short Circuit protection for safety use. Specification: Item Type: LED power supply Modulation Method: Pulse width modulation (PWM) Transistor Connection Method: Full-Bridge Output Power: 60W Output Current: 2.5A Work Efficiency: 95% Output Ripple Noise: 85mv Load Adjustment Rate: 5% Operating Temperature: -30~40℃ Dimensions: 18.5x3.5x2.5cm / 7.3x1.4x1.0in Package List: 1 x LED Power Supply Driver Note: 1. You must connect the lighting load at first, and then power on. 2. All leads are avoided from direct contact with the capacitive surface. 3. When assembling the luminaire, do not squeeze strongly to avoid deformation and damage of components. 4. Avoid direct contact between the exposed leads and the metal lamp housing. 5. After the power supply is assembled into the luminaire, it is necessary to carry out aging test for more than 24 hours according to the actual situation to ensure the quality of the luminaire product. 6. Try to avoid the electrolytic capacitor casing in the power supply directly contacting the casing of the lamp. 7. All power leads must use high temperature wires.