["Descriptions:\r\nThis meter is a small tool for the engineer, electronic maintenance and factory. It is very easy to test plug-in and SMD devices, it can also test different kinds of diodes, triodes, thyristors, MOSFET, enable to analysis the device type, the polarity of the pin, the output HFE, the for valve voltage, the junction capacitance of the FET.\r\n \r\n \r\nNotes: \r\nBefore testing the capacitor, be sure to discharge it, otherwise it may damage the internal circuit\r\nIf using for DC power supply, please choose for DC 9V - 12V adapter (including 9V and 12V)\r\nIt is powered by 1pcs of 9V 6LR61 battery, when the battery power is under 6V, please replace it with a new one\r\n \r\nParameters:\r\n \r\nResistor: 0 - 50M ohm        Resolution: 0.01 ohm\r\nCapacitor: 25pF - 100mF    Resolution: 1pF\r\nInductor: 0.01mH - 20H       Resolution: 0.01mH\r\nCapacitor ESR: 2uF-50mF  Resolution: 0.01 ohm\r\n \r\n \r\nHow to use instructions:\r\nPush \"POWER / TEST\" to power on and start a test, multiple measurements can be repeated by this for key, auto power off 20 seconds after measurement\r\nProvide three kinds of socket, each socket pin 1, pin 2 and pin 3 are connected\r\nThere is a table \"typical ESR value of electrolytic capacitor\" at the back, it is for guiding only, these are typical value for standard grade electrolytic capacitor at room temperature\r\n \r\nCalibration:\r\n \r\nShort the test pin 1, 2, 3 together and push \"POWER / TEST\" button, then the screen prompts to enter calibration, push the button again within 2 seconds to confirm. \r\nFew seconds latter the screen prompts to release pin 1, 2, 3, release them and wait for calibration finish\r\n \r\n \r\nPackage Weight: 0.25 kg \r\nPackage Size(L x for W x H): 17.50 x 10.00 x 6.00 for cm / 6.89 x 3.94 x 2.36 inches\r\nPackage Contents: \r\n1 x ESR02 PRO Digital Transistor Tester\r\n1 x English User Manual"]