1、Embedded with M.2 interface LTE module, supporting LTE (FDD) B1/B2/B3/B5/B7/B8/B20/B28. 2、Used for APAC network coverage in Europe and Asia Pacific, with low power consumption. 3、Can be more easily and flexibly designed and integrated in terminal equipment. 4、This wireless network card is a good choice for notebooks, tablets and ultrabooks. 5、Strict quality control and quality assurance, high safety factor, can be used with peace of mind. Item Type: Wireless Network Card Model: ME906S-158 Size: Height: Approx. 30mm / 1.2in Width: Approx. 42mm / 1.7in Depth: Approx. 2.3mm / 0.1in Composition Factor: 75-pin M.2 / NGFF LTE FDD: B1, B2, B3, B5, B7, B8, B20, B28 DC-HSPA + / HSPA + / HSPA / WCDMA: B1, B2, B5, B8 EDGE / GPRS / GSM 1900/1800/900/850 MHz Rate: EDGE: DL 236.8 kbps/UL 236.8 kbps WCDMA PS: DL 384 kbps/UL 384 kbps HSPA+: DL 21.6 Mbps/UL 5.76 Mbps DC-HSPA+: DL 42Mbps/UL 5.76 Mbps LTE FDD: DL 150 Mbps/UL 50 Mbps at 20M Bandwidth cat4 Interface: 2 x antenna interface M.2 Signal control interface USB 2.0 interface high speed USIM card Power Supply: 3.135 V To 4.4 V (typical Value: 3.3 V) GNSS: GPS independent, A-GPS, LTO, GLONASS SIM card hot swap IPV6 BodySAR Adjustable antenna Temperature Range: Normal Work: -10℃ to 55℃ Extended Operation: -20℃ to 70℃ Operator: For Vodafone/Orange/Australia Telecom/Spark New Zealand How to Use: 1. Use a small screwdriver to open the back cover of the laptop, and find the wireless network card. (The wireless network card is square and has two black and white wires connected. It is fixed by two small screws) 2. Use a screwdriver to unscrew the two fixed screws, put them aside, and save them. 3. Remove the old wireless network card and replace it with a new wireless network card, follow the original disassembled route to return to the installation, and fix it. 4. Then boot up and install the driver automatically. 1 x Network Card