1,The measurement circuit is isolated from the incoming signal. Hall‑type current conversion, which can withstand 30 times the nominal input, prevents instantaneous high current access and burns out the internal components of the sensor, which is very safe 2,Isolate the detection signal and the output signal, effectively filter the noise in the signal, greatly improve the signal-to-noise ratio and signal stability of the product, and effectively enhance the product's anti-interference ability 3,The primary and secondary sides of the hole current transmitter are highly insulated and isolated, featuring high accuracy, small size, low power consumption, wide frequency response, and anti-interference characteristics 4,Perforated input, no insertion loss, fixed with standard guide rail and flat screws, easy to install 5,Especially suitable for generators, motors, intelligent low-voltage power distribution cabinets, air conditioners, fans, street lamps, power grid monitoring, motor signal monitoring, railway system signal monitoring industries and other load current intelligent monitoring systems Item Type: AC Current Transmitter Material: ABS Power Supply: DC24V Installation Method: Standard rail and flat screw fixation Product Use: Used to measure AC current, especially for power frequency 50Hz sine wave AC current Rated Current: AC0-5A Rated Output: DC4-20mA Accuracy: 0.5 percent Overload Capacity: 30 Times the nominal input Temperature Drift: ≤500PPM or ℃ Linearity: 0.1 percent Frequency Bandwidth: 20-5KHz Current Consumption: <15mAand output current Response Time: <200ms Working Temperature: -109℃-and70℃ Storage Temperature: 25℃-85℃ 1 x AC Current Transmitter Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.