1. Compared with other similar ,this product adopts four-sided flat pressure of multi- pressure,precise positioning,avoiding capacitors,and is good for CPU fixation;2. The contact surface with the motherboard is a flat bottom,and the LOTES insulation protection pads of the same specification are used to reduce the pressure on the motherboard and further reduce signal interference;3. The metal side is raised to reduce signal interference on the motherboard side;4. Anode sandblasting is made of all-aluminum alloy precision,5.This product only provides support for 12th generation CPU,the motherboard CPU socket is LGA1700 chipset is H610 B660 Z690 seriesInstallation process:1. Place the motherboard horizontally on the desktop and open the CPU clip2. Use the included T20 Torx screwdriver to remove the upper part,and put the lower fastener 3. Put the CPU into the socket4. Cover the improved buckle on the top cover of the CPU and move it slightly until it clicks into place5. Tighten the screws in half a on the opposite corners. Each screw takes turns in half a and a half in the diagonal order until the screw is on. will put pressure on the CPU unevenly.size: 54 x 70 x 6mmMaterial: metalcolour: greyPackage Contents:1 x CPU Bending Correction Fixing Buckle1 x screwdriverOnly the above package content,other are not included.Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.