Installation:1. Disconnect and clean all engine and battery ground wires. 2. Disconnect the old CDM Module and remove the high tension coil wire from the . 3. Unbolt and remove the old CDM Module. (Note the direction of the wire). 4. Apply a light amount of to the seal area of the wire connector from the engine harness. 5. Apply a light amount of to the outside of the wire and thread the wire into the CDM Module. Bolt the CDM Module onto the engine (orient the CDM Module so that the wire is pointed in the same direction as the). Plug in the connector from the wire harness into the CDM Module and connect the wire to the . Replaceable part numbers: 114-7509, 827509A 1, 827509A 3, 827509A 4, 827509A 7, 827509A 8, 827509A 9, 827509A10, 827509T 7, 9-23202, AMW-3454 Applicable models:for Mercury For 200 6 cylinder engines 2000-2005 with serial For 30 2 cylinder engines 1996- 2006 with serial For 30 3 cylinder engines 1998-2001 with serial For 40 2 cylinder engines 1996-2005 with serial For 100 4 cylinder engines 1996-2000 with serial Colour:black Material:plastic Package Contents: 3 x Ignition Coil Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.