<p>The output will be turned off when the load current is continuously less than 50mA.</p> <p>Support external buttons, connect the button to K point and output negative pole, short press to turn on the power display and turn on the 5V output, two consecutive short presses will turn off the power display and turn off the 5v output.</p> <p>When the charging current to 100mA after reaching the final float voltage, the charging cycle will be automatically terminated.When the battery voltage 4.1V, the charging cycle restarts.When the battery voltage is lower than 2.8V, the battery will be precharged with a current of 180mA.</p> <p>The USB-A female socket welding position is provided on the back of the product, and the female socket can be manually installed.</p> <p>Support charging and discharging.</p> <p>This model is the second edition, which reduces the size under the same performance and is convenient for installation in small spaces.</p> <p>Product features: Type-C input, high charging voltage accuracy.</p> <p>Note: Adjusting the charging voltage setting requires power-off operation; the USB-A female socket on the back of the module is a 5V output terminal and needs to be soldered by the user. We will provide a female socket with the product.</p> <p>Basic parameters</p> <p>Input voltage range: 5~5.5V</p> <p>Charging cut-off voltage: (4.2V\/4.35V) +\/-0.5%</p> <p>Charging current: 2.4A+\/-5%</p> <p>Boost output voltage: 5V~5.15V (wire loss compensation)</p> <p>Boost output voltage ripple: 100mV</p> <p>Boost output current: 2A</p> <p>Boost conversion efficiency: 92.5% (3.6V input, 5V2A output)</p> <p>Battery end quiescent current: Less than 30uA</p> <p>colour:Black</p> <p>Material:Electronic component</p> <p>size:18x22x4.5mm</p> <p>Package Contents:</p> <p>1 x Lithium battery charge and discharge module</p> <p>Only the above package content, other products are not included.</p> <p>Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.</p>