TN-73 High-precision VU Meter DB Power Discharge Flat Meter Mixer Power Meter Specification 1. Movable part: movable coil type 2. Pointer materials: Nickel Silver Strips 3. Pointer color: Black 4. Direction of pointer swing: From left to right 5. Pointer length: 30+-1mm from the center axis to the end of the needle 6. Pointer width: 0.45 +- 0.05mm 7. Direction of use: Vertical 8. Operating temperature limit: -10 degree C to + 60 degree C RH 35 to 85% 9. Storage temperature limit: -20 degree C to + 60 degree C RH 35 to 85% 10. Solder condition: Put the terminal about 3 mm into a tin plate with a temperature of 230 degree C. The placement time is 3.5 seconds. After this test, 7-14 items remain normal. 11. Solder temperature: hold the solder gun at 350a?? for 3.5 seconds, and the front end of the terminal is about 3mm in contact with the solder gun. After this test, items 7-14 remain normal. 12. Anti-static: use dry nylon cloth to test the transparent cover surface in the same direction for three times. Mark the pointer difference below 13 of the scale length, and return to zero after three seconds. 13. Light bulb specification: DC12V 12W Note: Do not put the meter in direct sunlight, and store the meter in the packing box to prevent foreign matter from entering the meter Electrical Performance 1. Standard test conditions: temperature 20 degree C, humidity 70%, no difference in test results, it can also be tested under normal temperature and humidity. 2. Electric influenza degree: Pointer sensitivity 1mA+- 5% from zero scale to uppper scale (full scale position) 3. Internal impedance: 50ohm+- 5% 4. Insulation impedance: above 500V DC plus 50M OHm for the charging circuit of the meter outer box. Insulation impedance between the casing of the meter and the charging circuit is tested at 500V DC voltage. 5. Zero position: the meter is in a standard position. The place where the front end of the pointer is integrated with the zero scale center is