Compact frequency-output module with SMA output and single +5 V supply. Designed for easy integration into test setups and embedded systems that require precise, configurable frequency sources. Key specifications Supply voltage: +5 V. Output frequencies: F0 and F1 each adjustable from 2.5 kHz to 200 MHz. PLL arrangement: F2 and F1 share a phase-locked loop (PLL); the frequency division ratio is configurable to meet synchronization and multiplication/division requirements. Output interface: SMA jack for direct connection to instruments and RF cabling. Why customers need this product Simplifies system design by providing two wide-range frequency outputs (F0, F1) along with a PLL-shared F2/F1 arrangement for coherent timing and phase control. Reduces component count and integration time compared with building separate oscillators and PLLs. Configurable division ratio lets you adapt the module to different clocking schemes and synchronization needs without hardware changes. What makes it stand out Wide frequency range up to 200 MHz for both F0 and F1 gives flexibility across low-frequency timing and RF testing. Shared PLL between F2 and F1 enables phase-locked operation where a stable phase relationship is required. SMA output interface provides a standard, reliable connection to oscilloscopes, spectrum analyzers, mixers, and RF cabling. Compatibility and performance considerations Power with a regulated +5 V supply as specified. Output access via SMA jack for straightforward connectivity to measurement and RF equipment. Frequency control and PLL division are configurable to match system timing and synchronization needs. Practical applications / use scenarios Laboratory signal source: Use F0 or F1 as a bench frequency reference up to 200 MHz for testing and characterization of circuitry. Embedded clock generation: Provide a stable, configurable clock to digital or mixed-signal systems that require precise phase relationships between channels (using the shared PLL for F1/F2). RF test and measurement: Drive mixers, local oscillators, or calibration setups where a standard SMA connection is needed and a wide tuning range is required. Notes All specified functions and interfaces are as stated: +5 V supply, F0/F1 range 2.5 kHz–200 MHz, F2 and F1 sharing a PLL with configurable division ratio, and SMA jack output.