["Description:\nbrand new and high quality\nFeatures:\nThe drive performance of these non-L298 motor driver chip can be compared, for focus on current and efficiency, effectively motor power and battery life.\nCan withstand high current overload, the maximum current up to 30A.\nThis drive also has a brake function can be quickly stopped the motor, brake quickly, braking obvious, easy to implement this feature.\nThe drive uses the full two half-bridge driver chip + low resistance N-channel MOSFET components.\nCompleter two half-bridge driver chip reliable drive mode, the MOSFET switching losses to a minimum. Improve power utilization.\nMOSFET driver chip comes with hardware brake function and power feedback.\nThis drive is superior integrated low power chip solution and the other half-bridge power margin in the coordinated combination of programs and complex issues and complementary drive problems.\nN-channel MOSFET IRF3205 MOSFET, use two dedicated half-bridge driver chip on the top tube using the boostrap capacitor, so that the tube has enough drive voltage of the MOSFET channel can be opened quickly, improve motor acceleration curvature, but also quickly for the motor brake. This allows the trolley can quickly start can quickly kill the car.\nThe driver can operate at 0-99% of the duty cycle of the PWM modulation, the motor driving voltage can be obtained sufficiently.\n\nSpecifications:\nMotor reversal: DIR = 0 PWM = PWM\nParking brake: DIR = X PWM = 0 (X is an arbitrary state)\nMotor forward: DIR = 1 PWM = PWM\nPOWER connected to the positive power supply, GND power supply is negative. Two motors were connected MOTOR1, MOTOR2\nMotor and power connections\nRated Voltage: 3-36V\nRated Current: 10A\nfor Peak Current: 30A\nUse: for Freescale for smart car contest Undergraduate Electronic Design Contest variety of for DC motor control circuit\nDimensions(LxW): Approx. 108x58 mm/4.25x2.28 inch\n\nPackage Includes:\n1 Piece Dual Motor Driver Module Board"]