Matek Systems F722-WPX STM32F722RET6 Flight Controller Built-in OSD 2-6S FC for RC Airplane Fixed Wing Description: Brand: Matek Model: F722-WPX MCU: 216MHz STM32F722RET6 IMU: MPU6000 (SPI) Baro: DPS310 (I2C) OSD: Pixel OSD/FrskyOSD (Uart6) Blackbox: MicroSD socket (SPI) 6x UARTs(5 Spare) with built-in inversion 1x Softserial_Tx option 10x PWM outputs 1x I2C 4x ADC (VBAT, Current, RSSI, AirSpeed) 1x SH1.0_6pin connector (4V5/G/TX4/RX4/SDA/SCL) for GPS/compass 1x SH1.0_6pin connector for external USB and buzzer Dual Camera Inputs switcher Vbat filtered power ON/OFF switcher PWM camera menu control: Not supported by INAV DJI FPV air unit: any spare UART Power * 6~30V DC IN (2~6S LiPo) * 132A high-precision Current Sense (Scale 250) * PDB/Current sense resistor: 60A continuous, 132A burst. * BEC 5V 2A for FC & Peripherals * BEC Vx 5A for servos, 5V/ 6V option * Vbat filtered output 1A for VTx and Camera * LDO 3.3V 200mA * Battery Voltage Sensor: 1:10 (Scale 1100) FC Firmware INAV target: MATEKF722WPX Physical Dimensions: 44 x 29 x 10 mm Mounting: 25 x 25mm, 桅2mm Weight: 20g w/ bottom plate and USB/buzzer adapter * INAV2.5.x downloaded from configurator doesn鈥檛 support Barometer DPS310 and SD card. download customized firmware from here. * inav_2.5.1_MATEKF722PX_DPS310_SD.hex * DPS310 & SD in target will be supported officially by INAV2.6 and new configurator. * If Baro can鈥檛 be detected. In INAV CLI mode, type command 鈥?/span>set baro_hardware = DPS310鈥?/span> * Since INAV2.6, pls use target MATEKF722WPX * Update FrskyOSD to 2.0 https://github.com/FrSkyRC/PixelOSD/tree/master/firmware * INAV configurator nightly version 2.6 Package Included: 1x FC F722-WPX 1x USB(Type-C)/Buzzer (Active) Adapter 1x Bottom plate, 44 x 29mm 2x JST-SH-6P to JST-SH-6P cables, 20cm 5x Brass standoffs, M2*4mm 10x screws, M2*3.5mm Dupont 2.54 pins (Board is shipped unsoldered)