Feature: 1. This enclosure exclusively supports NVME M.2 M Key SSDs and does not support B+M key SATA M.2 NGFF SSDs. This enclosure is compatible with 2230 2242 2260 2280 sized M.2 SSD. 2. The JMS583 Type-C 3.1 controller chip ensures strong compatibility and stability while supporting UASP acceleration protocol to protect data security. This enclosure works with the mainstream NVME PCIE M.2 hard drive on the market. The USB 3.2 Type-A plug is compatible with USB 3.0 and 2.0 interfaces. 3. High-Speed Data Transfer: With USB 3.2 transfer speeds of up to 10Gbps, this enclosure can deliver real-world read transfer speeds of up to 1000MB/s (this data is for reference purposes only). The actual transfer speed depending on the device and SSD used. 4. The all-aluminum design aids in heat dissipation. This enclosure helps release the heat generated by a amount of data writing and reading and protects your valuable data. M.2 NVMe SSD Enclosure Supports Write Protection Function 1: After the write protection switch is turned on, no files can be put into the hard disk, and the hard disk will be invaded by . Function 2: When the write protection is turned on, the content of the file in the hard disk cannot be saved after modification, which can prevent the content from being modified by mistake. Function 3: After the write protection switch is turned on, any files in the hard disk cannot be deleted, which can prevent files from being deleted by mistake or maliciously. Specification: Material: Aluminum alloy Color: Gray Master control: JMS583 External interface: Type-c 3.1 Gen2 Theoretical transfer rate: 10Gbps Read and write speed:1000MB/S Support hard disk protocol: NVME Support hard disk interface: M Key Applicability: Supports M.2 NVME solid-state drives in 2230 2242 2260 2280 sizes Package Contents: 1 x SSD Enclosure 1 x cable 1 x USB A to USB C cable 1 x screwdriver Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.