Working Voltage: AC/DC 12V-36V (compatible with both AC and DC; wide voltage range from 12V to 36V including 12V, 14V, 16V, 18V, 24V, 28V, 36V) Working Current: 48mA Quiescent Current: 16mA Max Load: 10A Relay (optimal performance under 5A or 60W) Color: White Material: ABS Function: Receiver with manual button control and wired external button (transmitter not included) Connect the normally open external button to the pin (U--S--D--GND) to control motor forward and reverse operation Default Power State: OFF (if power is interrupted and restored, the unit remains OFF until manually turned ON) Output Mode: Momentary or Latched, selectable via jumper on receiver Jumper Settings: - Momentary: Jumper positioned on "1&2" - Latched: Jumper positioned on "3&4" (default setting) Operation Modes: Momentary Mode: - Press "Up" button: Motor runs forward; release to stop - Press "Down" button: Motor runs reverse; release to stop Latched Mode: - Press "Up" button: Motor runs forward; press "Stop" to halt - Press "Down" button: Motor runs reverse; press "Stop" to halt If limit switches are not used, connect UP and DOWN terminals with a jumper wire (factory pre-connected; remove if using limit switches) In Latched mode, a 0.5-second delay between forward and reverse is built-in for protection Package Contents: 1 x Wireless Remote Receiver (2 CR2016 button batteries not included) 1 x Receiving Controller Note: Only the items listed are included. Other accessories shown are not part of the package. Note: Lighting effects and monitor differences may cause slight variations in color representation. Measurement tolerance: +/- 1-3 cm.