High-performance MCU with RISC-V 32-bit dual-core and single-core processors. 128KB ROM, 16KB LP ROM, 768KB L2MEM, 32KB LP , 8KB TCM Strong image and voice processing capabilities, image and voice processing interfaces include JPEG codec, pixel processing accelerator (), image signal processor (ISP) and H264 video encoder. The chip package is encapsulated with 32MB PSRAM, and the module is integrated with 16MB Nor Flash. Common peripheral interfaces such as MIPI-, MIPI-, USB 2.0 OTG, Ethernet, SDIO 3.0 SD card slot, microphone, speaker terminal and RTC battery terminal are led out from the board. The board leads out 2 x 20 rows of pins and leads out 28 remaining programmable GPIO. Security mechanism: secure startup, Flash encryption, hardware encryption accelerator and hardware random number generator. At the same time, it also supports hardware access protection, which can realize access right management () and privilege separation. Development board introduction: This product is a dual-core and single-core RISC-V high-performance development board based on ESP32-P4. It supports rich human-computer interaction interfaces, including MIPI- (Integrated Image Signal Processor ISP) and MIPI- interfaces, as well as common peripherals such as SPI, 12S, 12C, LED PWM, MCPWM, , ADC, UART and TWAI. It also supports USB OTG 2.0 HS, Ethernet and SDIO Host 3.0 for high-speed connection. ESP32-P4 chip integrates digital signature peripherals and special key management unit to the security of data and operation. ESP32-P4-WIFl6-DEV-KIT is specially designed for high-performance and high-security applications, which fully meets the higher requirements of embedded applications for man-machine interface support, edge computing ability and IO connection characteristics. Color:As Shown Material:PCB Package Contents: 1 * Development Board Kit Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.