Wind Generator Controller 12/24V 800W MPPT Wind Charge Controller for Wind Turbine Systems Automatically charges the battery. The controller features an integrated rectifier and brake circuit module, offering improved heat dissipation and reliability compared to traditional designs. Designed with a fully sealed, waterproof enclosure, achieving an IP67 protection rating, allowing for long-term operation even when submerged in water. Ensure the wind turbine generator output voltage matches the battery's rated voltage. Connect wiring in the correct sequence: first connect the battery's positive and negative terminals to the corresponding red (positive) and black (negative) terminals on the controller, then connect the wind turbine's three-phase output to the green three-phase input terminals. Follow all connection instructions carefully. Reversing polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring Instructions: 1. Connect the battery's positive and negative terminals to the controller's battery terminals (red for positive, black for negative). 2. Connect the wind turbine's three-phase output to the controller's three-phase input (green terminals). Specifications: - Maximum input AC voltage: AC 35V - Output voltage: 12V / 24V - Battery charging cut-off voltage: 14.5V ± 0.3V (12V), 29V ± 0.3V (24V) - Maximum charging current: 15A (12V), 10A (24V) - Wind generator speed limit voltage: 14.5V ± 0.3V (12V), 29V ± 0.3V (24V) - Protection level: IP67 - Static power consumption: 0.008A - Maximum load power: 800W - Maximum allowable wind speed: 12 m/s - Operating temperature range: -35°C to 65°C - Input wiring: Three-wire system - Control mode: Auto-detect 12V/24V - Installation: Bolted mounting - Do not reverse polarity to prevent damage Application: Designed for use with wind turbine generator systems. Product Color: Blue Material: Aluminum alloy Package Includes: 1 x MPPT Wind Generator Controller Note: Other items not included. Color may vary slightly due to lighting and display differences. Measurement tolerance: ±1–3 cm.