1. Recording REC means that pressing and holding the REC button causes the LED to light up. At this point, speaking into the MIC records the content into the ISD1700 voice chip. After recording a segment, the LED turns off automatically. Pressing the button again starts recording the next segment, with subsequent segments recorded sequentially. 2. Press the playback PLAY button to play back recordings. There are two trigger modes: edge trigger and level trigger. (1) Edge trigger: Click the PLAY button once to play the current segment. The LED flashes during playback and stops when playback ends. After playback completes, the playback pointer remains at the start address of the last played segment. Press PLAY again to replay the same segment. (2) Level trigger: Press and hold the PLAY button to continuously play all recorded messages in a loop until the button is released. 3. Fast forward FWD operation: Before playback, press the FWD button to move the playback pointer to the next segment. Each press advances the pointer by one segment. During playback, pressing FWD stops the current segment and starts playing the next one. If the last segment is playing, pressing FWD stops playback and returns to the first segment. 4. ERASE button operation: Single-segment erase is only valid for the first and last segments. When the playback pointer is on the first or last segment, pressing ERASE deletes that segment. The playback pointer then moves to the second or second-to-last segment before deletion. Press and hold the ERASE button for more than 3 seconds to enter "all erase mode." The LED flashes twice. Continue holding; the LED flashes 7 times and then turns off. Release the button to completely erase all voice data from the chip. 5. RESET button operation: Pressing RESET initializes the system. After reset, both playback and recording pointers default to the last segment. The playback pointer points to the beginning of the last segment, and the recording pointer points to the end of the last segment. Playback starts from the last segment, and new recordings begin after the last recorded segment. 6. Volume control VOL: Press the button to adjust the output volume. Each press decreases the volume by 4dB until minimum is reached. Further presses increase the volume by 4dB per click. After reset, the default volume setting is maximum. 7. FT pass-through operation: Connect the FT pin to GND to enable pass-through mode. In this mode, o input from the Analn terminal is routed directly to the speaker or AUD output. During recording, if FT is activated, the incoming o signal is simultaneously recorded. 1 x Recording and Playback Module Item Type: Recording module Size: Approx. 5.5 cm x 5 cm (2.2 in x 2.0 in) Power Supply: 5V Recording Time: 75 seconds at 6KHz, 60 seconds at 8KHz Chip Operating Frequency: Selectable between 6KHz and 8KHz Indicator Light: Includes power indicator and chip status indicator