Equipment: 100-piece Tile Leveling System Floor Kit Features: - Wear-resistant, recyclable, and reusable - Simple DIY operation, easy to use - Balances tiles in the same horizontal position - Improves tiling speed - Reduces installer fatigue and stress - Creates a nearly flat, crack-free surface - Reduces the need for sharpening and polishing - Prevents tiles from shifting during the curing process Specifications: - 1 pack of 50 pieces, includes 1 wrench, pin thickness 1.5 mm - Total of 100 pieces - Weight: 0.56 kg per bag (may vary slightly) Instructions: - Lay the first tile, leaving a gap of more than 2 mm (cross spacers recommended) between tiles - Insert a T-pin next to the gap between tiles, then rotate it 180 degrees to connect the T-pin under the two adjacent tiles - Adjust the cap by hand or with the included wrench until the tiles are level - After approximately 5–6 hours of leveling, and before the adhesive fully dries, rotate the cap in the opposite direction and pull the T-pin out at 180 degrees to remove it cleanly Tips for best results: - Maintain tile joints greater than 2 mm (use cross spacers) - Clean excess adhesive around the T-pin during installation - Remove the T-pin 5–6 hours after installation, before the adhesive completely cures Note: - Due to differences in display screens and lighting, the actual product color may vary slightly from the image - Slight measurement variations may occur due to manual measurement